پروگرامر و دیباگر ST-LINK V2 مخصوص تراشه های STM8 و STM32

پروگرامر و دیباگر ST-LINK V2 مخصوص تراشه های STM8 و STM32

پروگرامر و دیباگر ST-Link V2 دیباگر و پروگرامر برای میکروکنترلرهای سری STM8 و STM32 می باشد که از پروتکل های رابط تک سیم (SWIM) و اشکال زدایی سری JTAG / سریال (SWD) برای برقراری ارتباط با میکروکنترلر STM8 و STM32 استفاده می کند. علاوه بر ارائه عملکردهای مشابه ST-LINK / V2 ، ST-LINK / V2-ISOL دارای ایزولاسیون دیجیتال بین کامپیوتر و برد کاربردی هدف نیز می باشد.

Introduction

The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. In addition to providing the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. It also withstands voltages of up to 2500 VRMS. STM8 applications use the USB full speed interface to communicate with STMicroelectronic’s ST Visual Develop (STVD) or ST Visual Program (STVP) software. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

Feature

5 V power supplied by a USB connector

USB 2.0 full-speed compatible interface

USB Type-A to Mini-B cable provided

SWIM specific features:

1.65 V to 5.5 V application voltage support on the SWIM interface

SWIM low-speed and high-speed modes support

SWIM programming speed rates: 9.7 kbyte/s in low-speed, 12.8 kbyte/s in high-speed

SWIM cable for connection to an application with an ERNI standard connectorVertical connector reference: 284697 or 214017Horizontal connector reference: 214012

SWIM cable for connection to an application with pin headers or 2.54 mm pitch connector

JTAG/serial wire debug (SWD) specific features:

1.65 V to 3.6 V application voltage support on the JTAG/SWD interface and 5 V tolerant inputs

JTAG cable for connection to a standard JTAG 20-pin 2.54 mm pitch connector

JTAG support

SWD and serial wire viewer (SWV) communication support

Direct firmware update support (DFU)

Status LED blinking during the communication with the PC

Operating temperature from 0 °C to 50 °C

1000 Vrms high isolation voltage (ST-LINK/V2-ISOL only)